Hunter Douglas Blinds Battery Replacement: How to Change the Batteries
Updated
A Hunter Douglas blinds battery replacement takes a few minutes and no tools. The cells live in a battery wand, a plastic tube clipped to the headrail. Take the wand out, put a full set of new AA cells in, put it back. There is no recalibration and no re-pairing afterwards: Hunter Douglas's own battery-change steps end when the wand goes back in, because the shade's limits and pairing live in the motor, not the wand.
Already know it is the wand? Genuine 18V and 12V wands from $17.95 ↓
This page is about the cells. If the wand itself has failed, fitting a new one is covered on how to replace a Hunter Douglas battery wand.
How many batteries do Hunter Douglas blinds take?
Eight AA or twelve AA, depending on how the shade was built and ordered. Hunter Douglas says the same thing in its own guides: PowerView shades use eight or 12 AA alkaline batteries depending on the product configuration. Eight cells means the 12V wand; twelve cells means the 18V wand.
| Shade line | Batteries | Wand |
|---|---|---|
| Duette and Applause honeycomb, from May 2010 | 8 or 12 AA, built with both | 12V or 18V, so count |
| Silhouette window shadings, from May 2010 | 8 or 12 AA, built with both | 12V or 18V, so count |
| Vignette modern Roman, from May 2010 | 8 or 12 AA, built with both | 12V or 18V, so count |
| Nantucket, Sonnette, Duette Vertiglide | 8 or 12 AA, built with both | 12V or 18V, so count |
| Solera soft shades | Count to confirm | 12V or 18V |
| Provenance woven wood | 12 AA | 18V only |
| Designer Roller, Screen and Banded | 12 AA | 18V only |
| Parkland and EverWood wood blinds, from May 2018 | 8 AA | 12V only |
| Modern Precious Metals, from May 2018 | 8 AA | 12V only |
| Palm Beach shutters | 8 AA | 12V only |
| Pirouette over 23 inches wide | 12 AA | 18V |
| Pirouette 18 to 23 inches wide | 8 AA | A different part, 7520073000, which we do not stock |
| Most PowerRise 1.0 shades | 8 AA | 12V |
| Duette and Applause with SkyLift, made after April 2013 | 16 AA lithium | Two wands in the bottom rail, not ours |
Where the table says count, Hunter Douglas genuinely used both wands on that line, and only your own headrail can tell you. Not sure? Buy twelve; you will know once the wand is open. Every line, with Hunter Douglas's own notes, is on the compatibility list.
- Twelve AA: the Hunter Douglas 18V battery wand, part 7520068000
- Eight AA: the Hunter Douglas 12V battery wand, part 7520069000
Which batteries should I buy?
A full set of new AA alkaline cells, all the same brand, from the same pack. Hunter Douglas recommends alkaline AA for most shades, names Duracell and Energizer, and says lithium offers no major performance benefit in PowerView or PowerRise shades while costing significantly more.
The exception is Duette and Applause with SkyLift. Hunter Douglas says those shades should use lithium AA, and its SkyLift battery guide specifies 16 AA Energizer Ultimate Lithium. On a SkyLift shade the batteries are in wands in the bottom rail: remove the bottom rail cover, unplug the wands from the power cable, and replace the batteries following the label inside.
Why the brand and the matched set matter is on which batteries?, and the case for lithium elsewhere is argued on lithium vs alkaline.
Where is the battery wand on my blinds?
Usually at one end of the headrail, clipped into a bracket: a white tube about 14 inches long for the twelve-cell wand, about 10 inches for the eight-cell one.
- Raise the shade fully. Honeycomb and Roman fabric stacks into the headrail and hides the wand until the shade is all the way up.
- On a wood blind, tilt the slats open so you can reach behind them.
- Look behind any fascia or valance trim. On a deep Duette Architella headrail the wand is recessed further back than you expect.
- On Designer Roller, Screen and Banded shades Hunter Douglas says the wand is mounted behind the shade, typically on the same side as the motor. Raise the fabric and reach behind it.
- On a Sonnette the wand sits in two clips on the motor side, inside the headrail.
How do I change the batteries, step by step?
1. Take the wand out of its bracket. On most headrails it slides out lengthways. On Designer Roller, Screen and Banded shades, pull it downward out of the bracket, then unplug the cable from the wand only, never from the shade.
2. Open the battery compartment at the end of the tube. Wands made from May 2018 have Hunter Douglas's enhanced end caps, which make this easier, so a newer wand may look a little different from one you changed years ago.
3. Tip the old cells out, keeping the tube level. Look at them. White or green crust means trouble, covered below.
4. Read the orientation diagram printed on the tube. Every time. The cells are wired in series, so one battery in backwards is charged by the others, and on the 18V wand that blows the fuse in the end cap, which is not serviceable.
5. Fill every channel with new cells. All new, all one brand. Do not keep a few old ones because they seemed fine; the string performs like its weakest cell.
6. Plug the cable back in if there is one, and seat the wand until it clicks. On a Sonnette, push it up into the clips until it clicks and check it touches the top of the headrail; Hunter Douglas warns a part-seated wand can fall out or damage the fabric.
7. Test from the headrail. Press and release the small programming button on the headrail and the shade should travel. Then run one full cycle from the remote.
Do I need to recalibrate or re-pair the shade? No. Nothing needs re-programming after a battery change. If the shade moves from the headrail button but ignores the remote, see shade not working after new batteries: Hunter Douglas says a shade with a poor power supply can lose its programming, and re-pairing is free.
Write the date on the wand. Hunter Douglas suggests it, and it tells you next time whether a set ran its expected year or drained early.
What if my wand is rechargeable?
Then there are no AA cells to change. A sealed body with a small round charging socket at one end and nothing removable is Hunter Douglas's rechargeable battery wand: it gets charged, not refilled. Hunter Douglas says a full charge lasts about a year on a typical shade, the Single Charger takes about two hours and the Dual Charging Station up to three, and only Hunter Douglas chargers should be used. Some newer PowerView Gen 3 shades have an internal rechargeable battery and no wand at all; they charge through an adapter at the right side of the shade.
Do not put rechargeable AA cells in an ordinary wand instead. Hunter Douglas does not recommend them: most charge only to 1.2V against an alkaline's 1.5V and do not deliver the current the shade needs. See battery wand charger and Hunter Douglas rechargeable battery wand.
Two wands that do not follow these steps
- A sealed tube that will not open, with no charging socket. Its cells cannot be changed. The battery tube conversion kit replaces it with an external eight-AA tube.
- The rechargeable wand, above.
When is the wand itself the problem?
Fresh cells fix most shades. They will not fix these:
- White or green crust inside the tube, or cells that will not slide out. Leaked batteries have eaten the contacts, and cleaning buys weeks at best.
- Total silence on a fresh, correctly loaded set. No travel, no jog, no sound from the headrail button. Usually a reversed cell has blown the fuse.
- It works when you tap or reseat it, then quits. A contact has lost its spring.
- It has been dropped. Hunter Douglas says to replace a dropped wand or battery even when it looks fine.
A corroded wand may be free. Hunter Douglas's Legacy PowerView battery guide says that if you see corrosion in the wand, request a replacement and it provides a new wand free of charge; its Gen 3 guide says you may be eligible for a free replacement. Ask your dealer or Hunter Douglas before you buy one.
Is it the wand? confirms it in two minutes.
What we stock
Count the channels in the old wand: twelve or eight decides it.
- 18V battery wand, twelve AA, part 7520068000, $17.95
- 12V battery wand, eight AA, part 7520069000, $17.95
- Battery tube conversion kit, eight AA, for sealed tubes
- Motor to wand power cable, PowerRise, 13 inch
All new, genuine Hunter Douglas stock, shipped free by UPS Ground within the United States, same business day on orders placed before 3pm Eastern, usually delivered in 1 to 6 business days, with 30-day returns.
Not sure what you are looking at? Email a photo of the wand or your headrail sticker to support@batterywands.com, or call (609) 474-4242 weekdays, 9am to 5pm Eastern.
Sources: Hunter Douglas Help Center articles "Change Legacy PowerView Batteries" (39853673215892), "Replace PowerView Gen 3 Batteries" (39854067153940), "Battery FAQs for PowerRise and PowerView" (39426525094548), "Replace Duette and Applause SkyLift Batteries" (41323598760468), "PowerView Battery Wand Identification" (42770291229076), "How long does the charge last on my PowerView battery wand or rechargeable battery wand?" (39321136759188), "Charge a Rechargeable Battery" (39311961154324), "Why does my PowerView programming keep disappearing?" (39614475834388), "Replace Battery Wand for Designer Roller, Designer Screen Shades, and Designer Banded Shades" (40023376245652) and "Operate Sonnette with SoftTouch" (39887781156116).
Replacement parts. Complete your repair.
Common parts for Hunter Douglas motorized shades.



